NTDK20JA SSC card NTDK20JA SSC card nortelcs100e5 (TechnicalUser) (OP) 5 Apr 08 13:22 Hi all, i have a SSC card having Eng. code NTDK20JA, can i install Release 5 software with that SSC card? does it works ok? RE: NTDK20JA SSC card M1tel (Programmer) 5 Apr 08 16:45 This is a mouthfull but it sould helpFor CS 1000 Release 5.5 software, the minimum requirements are:• 32 Mbyte DRAM• 16 Mbyte primary ?ash• 48 Mbyte program storeNote: The NTDK97 Mini System Controller (MSC) card, which has16 Mbyte DRAM, is not supported for CS 1000 Release 5.0 andlater. The software cannot ?t on the 32 MBytes of program store onthe MSC card. Refer to Note 3 at the bottom of Table 21 "Systemcontroller card requirements for Small Systems" (page 84) for details.An NTDK20 SSC card with 32 Mbyte DRAM and equipped with an NTTK13or NTTK25 Software daughterboard meets the minimum requirements.New systems are shipped with the NTDK20HA SSC card equipped with theNTTK25CA Software daughterboard.Existing Cabinet or Chassis systems equipped with earlier vintages of theSSC card must:• upgrade the SSC card using the NTDK19 SSC upgrade kit• if necessary, upgrade to the NTTK25 Software daughterboardNote: If you are installing a new software daughterboard on an oldervintage SSC card, you must upgrade the boot code on the SSC cardbefore installing the new daughterboard.System controller card requirements for Small SystemsSystem configuration Main Cabinet/Chassis Expansion Cabinet/ChassisSingle cabinet • NTDK20HA SSC• Upgraded NTDK20AB-GASSC (see Note 2)n/aFiber expansion Cabinetsystem• NTDK20HA SSC• Upgraded NTDK20AB-GASSC (see Note 2)n/a(use Fiber Receiver card)IP expansion Cabinetsystem• NTDK20HA SSC• Upgraded NTDK20EA-GASSCNTDK20HA SSCUpgraded NTDK20AB-GA SSC(see Note 2)Single chassis • NTDK20HA SSC• Upgraded NTDK20EA-GASSC• NTDK97AD MSC (see Note3)n/aFiber expansion Chassissystem• NTDK20HA SSC• Upgraded NTDK20EA-GASSCn/a(use Fiber Receiver card)IP expansion Chassissystem• NTDK20HA SSC• Upgraded NTDK20EA-GASSC• NTDK20HA SSC• Upgraded NTDK20EA-GASSCNote 1: The term upgraded NTDK20xx refers to an SSC card vintage NTDK20xx on which theNTDK19 Upgrade Kit is installed.Note 2: NTDK20AB/CA Rls. 1-5 is not supported on upgrades. Refer to Product BulletinP-2004-0067-Global.Note 3: Maximum capacity in a TDM solution is 160 TDM TNs and 2000 Corporate Directory entries.