I am planning to install a new MSDL card and DNUM's 0 to 15 are filled (61C single group). To free up a DNUM I can remove a TTY on a paddle board. Both TTY/DNUM 4 & 5 are on a XSDI card. Can I just remove one DNUM and leave the other, or must both be removed? i.e. can the MDSL card use DNUM 4 while TTY 5 remain's on the paddle board? I suspect not...
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.