The customer has a Bogen C35 (specs are at bottom of post). What I would like to do is hookup a ringer to the page system. I don't know how to physically do this (what hardware to use)
I plan on creating "ring group 4" which will consist of Ext 23,24,25. Ext 23 and 24 are warehouse phones. 25 is an open port. I assume that I would run a cord from ext 25 to some device which in turn hooks up to amp.
Is this correct? What device can I use to convert the ringing from Ext 25 to an audible signal and then hook to the AMP? Where would I hook it to the amp?
AMP Specs -
THIS 35 WATT PUBLIC ADDRESS MIXER PROVIDES MIXING OF MICROPHONES, TELEPHONE, AND AUXILIARY SOURCES. OUTPUT JACKS ALLOW A TAPE RECORDER OR AN ADDITIONAL BOOSTER AMPLIFIER TO BE CONNECTED. THIS AMPLIFIER OFFERS HIGH-PERFORMANCE, FLEXIBILITY, AND RELIABILITY FOR MOST APPLICATIONS REQIRING A VARIETY OF INPUTS.
4 INPUTS:1 MIC (LO-Z),1 AUX (HI-Z), 1 TEL, PLUS 1 SELECTABLE MIC OR AUX
AUX MUTING W/ EXTERNAL CONTACT CLOSURE OR AUTOMATIC W/ TEL
TEL INPUT VOICE-ACTIVATED (VOX) AUX INPUT
VARIABLE THRESHOLD FOR VOICE-ACTIVATED AUX MUTE
SEPARATE VOLUME CONTROLS FOR EACH INPUT PLUS OVERALL BASS AND TREBLE
OUTPUTS FOR 4-OHM, 8-OHM, 16-OHM, 25V, AND 70V SPEAKER SYSTEMS
SCREW TERMINAL CONNECTIONS FOR MICROPHONES
INPUT SENSITIVITY:600 MV, MIC;85 MV, AUX;75 MV, TEL
THERMAL PROTECTION AND ELECTRONIC SHUTDOWN
OUTPUT JACK TO CONNECT TO TAPE RECORDER OR BOOSTER AMPLIFIER
EASY-TO-UNDERSTAND AND EASY-TO-OPERATE CONTROLS
RACK MOUNTABLE W/ ACCESSORY MOUNTING KIT (2 RACK SPACES)
UL AND CSA LISTED