Ok, I have a switch (1900) that currently has no IOS. When I go to install it via Xmodem, I get to the point on hyperterminal where it is says "Waiting for configured baud rate". I then go to transfer, send file via Xmodem and select IOS. The byte transfer comes up, and then says "transfer cancelled by remote system". Then back to the main menu. Thats as close as I get. I've on the reguler setting (9600, no par, no FC etc. ) reset switch to have the same. Am I doing something wrong? lonomac is online now Edit/Delete Message
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.